Call Us Today! 208-734-7426
2390 Rostron Circle | Twin Falls, ID 83301
Request A Quote

EPS Roofing Systems from Northwest Foam Products, Inc.

Contractors and architects are increasingly finding that roofing systems using Expanded Polystyrene (EPS) from Northwest Foam Products, Inc. can meet the needs of the most demanding building requirements. EPS offers measurable energy savings, long-term R-value, effective water resistance, and dimensional stability and strength when properly installed and protected from moisture. These systems may include flat and/or tapered foam insulation for use in traditional built-up assemblies and most single-ply membrane systems.

Tapered EPS Board
Customs EPS Valley
Custom EPS Hip

Moisture is extremely detrimental to any roofing system. The purpose of the membrane is to keep the water out. However, in the event of water penetration, EPS has been shown to effectively resist moisture and retain its mechanical properties. The moisture content of EPS insulation samples ranging in age from 6 to 15 years was found to be very low, i.e. a maximum of 0.04% by volume. Likewise, results for R-value performance indicated no deterioration in R-value over time, meaning EPS thermal resistance values may be used without adjustments for aging.

EPS roof insulations are compatible with most commercial roofing systems, including but not limited to built-up roofing, modified bitumen systems, and single-ply membrane systems that are either ballasted, mechanically fastened, or fully adhered. Expanded polystyrene insulation meets the requirements of ASTM C 578 Standard Specification for Rigid, Cellular Polystyrene Thermal Insulation. When specifying EPS insulation using ASTM C 578, the best possible product selection is ensured.

Contact us at Northwest Foam Products, Inc. to learn more about our roof insulation solutions and to get started with an appointment today.

We Cover the Following States:

  • Utah
  • Oregon
  • Washington
  • Idaho
  • Montana
  • Wyoming
  • Colorado
  • Nevada
Northwest Foam Products, Inc. |
2390 Rostron Circle | Twin Falls, ID 83301
| 208-734-7426 | info@northwestfoam.com